Symptom-to-FRU index
Symptom-to-FRU index
The sym ptom-to-FRU index in this section lists symptoms
and errors and their possible causes. The most likely
cause is listed first, in boldface type.
Note: Do the FRU replacement or other actions in the
sequence shown in the column headed “ FRU or
action, in sequence.” If replacing a FRU does not
solve the problem, put the original part back in the
computer. Do not replace a nondefective FRU.
This index can also help you determine, during regular
servicing, what FRUs are likely to need to be replaced
next.
A numeric error is displayed for each error detected in
POST or system operation. In the displays, n can be any
number.
If no numeric code is displayed, check the narrative
descriptions of symptoms. If the sym ptom is not described
there, go to “ Intermittent problems” on page 59.
Note
For an IBM device not supported by diagnostic
codes in the ThinkPad notebook computers, see the
manual for that device.
Numeric error codes
Symptom o r error FRU o r action, in sequence
0175
Bad CRC1, stop POST
task—The EEPROM checksum
is not correct.
System board.
0176
System Security—The System
has been tampered with.
1. Run IBM BIOS Setup
U tility and Load Setup
Defaults.
2. System board.
0177
Bad SVP data, stop POST task.
System board.
0182
Bad CRC2. Enter BIOS Setup
and load Setup Defaults.
Run IBM BIOS Setup U tility
and Load Setup D efaults.
0185
Bad startup sequence settings.
Enter BIOS Setup and load
setup defaults.
Run IBM BIOS Setup U tility
and Load Setup Defaults
ThinkPad R40 5 3
To Next Page
Loading...
Need help?
General