Removing and replacing FRUs
Field replaceable units (FRUs) must be installed only by trained service technicians.
Removing a non-hot-swap power supply
This procedure applies only to server models that have a non-hot-swap power
supply. See “Removing a hot-swap power supply” on page 72 for information about
the removal of a hot-swap power supply.
When you remove or install a non-hot-swap power supply, observe the following
precautions.
Statement 8:
CAUTION:
Never remove the cover on a power supply or any part that has the following
label attached.
Hazardous voltage, current, and energy levels are present inside any
component that has this label attached. There are no serviceable parts inside
these components. If you suspect a problem with one of these parts, contact
a service technician.
Chapter 4. Removing and replacing server components 105
To Next Page
Loading...
