Installing a CD or DVD drive
To install a CD or DVD drive, complete the following steps:
1. If you are replacing a removed drive with a new drive, make sure that:
v You have all the cables and other equipment that is specified in the
documentation that comes with the new drive.
v You check the instructions that come with the new drive to determine
whether you must set any switches or jumpers on the drive.
v You have removed the drive retainer clip on the side of the old drive and
have it available for installation on the new drive.
Note: If you are installing a drive that contains a laser, observe the following
safety precaution.
Chapter 4. Removing and replacing server components 63
To Next Page
Loading...
