v IBM Advanced Settings Utility (ASU) program
Use this program as an alternative to the Setup utility for modifying UEFI settings
and IMM settings. Use the ASU program online or out of band to modify UEFI
settings from the command line without the need to restart the server to run the
Setup utility. For information about using this program, see “IBM Advanced
Settings Utility program” on page 73.
Using the Setup utility
Use the Setup utility, to perform the following tasks:
v View configuration information
v View and change assignments for devices and I/O ports
v Set the date and time
v Set and change passwords
v Set the startup characteristics of the server and the order of startup devices
v Set and change settings for advanced hardware features
v View, set, and change settings for power-management features
v View and clear error logs
v Resolve configuration conflicts
Starting the Setup utility
To start the Setup utility, complete the following steps:
1. Turn on the server.
Note: Approximately 3 minutes after the server is connected to ac power, the
power-control button becomes active.
2. When the prompt <F1> Setup is displayed, press F1. If you have set an
administrator password, you must type the administrator password to access the
full Setup utility menu. If you do not type the administrator password, a limited
Setup utility menu is available.
3. Select the settings to view or change.
Setup utility menu choices
The following choices are on the Setup utility main menu. Depending on the version
of the IBM System x Server Firmware (server firmware), some menu choices might
differ slightly from these descriptions.
v System Information
Select this choice to view information about the server. When you make changes
through other choices in the Setup utility, some of those changes are reflected in
the system information; you cannot change settings directly in the system
information.
This choice is on the full Setup utility menu only.
– System Summary
Select this choice to view configuration information, including the ID, speed,
and cache size of the microprocessors; machine type and model of the
server; the serial number; the system UUID; and the amount of installed
memory. When you make configuration changes through other choices in the
Setup utility, the changes are reflected in the system summary; you cannot
change settings directly in the system summary.
– Product Data
62 IBM System x3850 X5 and x3950 X5 Types 7145 and 7146: Installation and User’s Guide
To Next Page
Loading...
Need help?
General
