IBM x3850 X5 7145 User Manual

Installing a QPI wrap card
Wrap card
Release
latch
If your server has more than two microprocessors installed, you must install two
QPI wrap cards in the server.
To install a QPI wrap card, complete the following steps:
1. Read the safety information that begins on page v and “Installation guidelines”
on page 25.
2. Turn off the server and peripheral devices, and disconnect the power cord and
all external cables.
3. Rotate the blue release latch on the QPI wrap card handle and pull the handle
to the open position.
4. Push the wrap card into the bay, and slide the handle to the locked position.
5. Reconnect the cables and power cords (see “Connecting the cables” on page
59).
6. Turn on all attached devices and the server.
Chapter 2. Installing optional devices 43

IBM x3850 X5 7145 Specifications

General

Processor	Intel Xeon E7-4800 series
Form Factor	4U Rack
Network Interface	Integrated dual-port Gigabit Ethernet
Chipset	Intel 7500
Memory Type	DDR3
Max Processors	4
Storage	Up to 8 HDDs or SSDs
RAID Support	RAID 0, 1, 5, 6, 10
Memory	Up to 1TB DDR3