EasyManuals Logo

IBM x3850 X5 7145 User Manual

IBM x3850 X5 7145
102 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #60 background imageLoading...
Page #60 background image
Memory modules
The following notes describe the types of dual inline memory modules (DIMMs) that
the server supports and other information that you must consider when you install
DIMMs:
v The server supports 1.5 V, 240-pin, 1 GB and 2 GB PC3-10600 or 4 GB, 8 GB,
and 16 GB PC3-8500 double data-rate (DDR) III, registered synchronous
dynamic random-access memory (SDRAM) with error correcting code (ECC)
DIMMs. These DIMMs must be compatible with the latest PC3-10600 or
PC3-8500 SDRAM Registered DIMM specifications. For a list of the supported
optional devices for the server, see http://www.ibm.com/servers/eserver/
serverproven/compat/us/.
v The server supports up to eight memory cards. Each memory card holds up to
eight DIMMs.
v At least one memory card with one pair of DIMMs must be installed for the
server to operate.
v When you install additional DIMMs on a memory card, be sure to install them in
pairs. The DIMMs in each pair must match each other.
v You do not have to save new configuration information to the IMM when you
install or remove DIMMs. The only exception is if you replace a DIMM that was
designated as disabled in the Setup utility Memory Settings menu. In this case,
you must re-enable the row in the Setup utility or reload the default memory
settings.
v When you restart the server after you add or remove a DIMM, the server
displays a message that the memory configuration has changed.
v Memory cards in connectors 1 and 2 support microprocessor 1, memory cards in
connectors 3 and 4 support microprocessor 2, memory cards in connectors 5 and
6 support microprocessor 3, and memory cards in connectors 7 and 8 support
microprocessor 4.
v There are four memory power buses, which are split among the eight memory
cards.
v Populate the memory-card connectors to match the microprocessor installation,
in the following order: 1, 7, 3, 5, 2, 8, 4, 6. (Microprocessors must be installed in
the following order: 1, 4, 2, and 3. See “Installing a microprocessor” on page 55
for more information.)
46 IBM System x3850 X5 and x3950 X5 Types 7145 and 7146: Installation and User’s Guide

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the IBM x3850 X5 7145 and is the answer not in the manual?

IBM x3850 X5 7145 Specifications

General IconGeneral
ProcessorIntel Xeon E7-4800 series
Form Factor4U Rack
Network InterfaceIntegrated dual-port Gigabit Ethernet
ChipsetIntel 7500
Memory TypeDDR3
Max Processors4
StorageUp to 8 HDDs or SSDs
RAID SupportRAID 0, 1, 5, 6, 10
MemoryUp to 1TB DDR3

Related product manuals