Icom IC-2100H

37
9
SCAN OPERATION
■ Scan start/stop
D Preparation
➥ Common setting: scan resume condition (p. 41)
➥ For programmed scan: program the scan edges (p. 38)
➥ For memory scan: program 2 or more memory chan-
nels; set memory skip settings, if
desired (p. 40)
D Operation
➀ Select VFO mode for full/programmed scan with [V/MHz];
or memory mode for memory scan with [M/CALL].
➁ Set the squelch to the point where noise is just muted.
➂ Push [(V/MHz)SCAN] for 1 sec. to start the scan.
• To change the scanning direction, rotate the tuning dial.
• The memory channel readout indicates the scan type as follows:
During full scan
Push [SET] to select full scan
or programmed
scan in sequence.
X
9
5
1
During programmed scan
Indicates scan edge channels.
• P1 stands for 1A/1b.
• P1 to P3 are available when
they are programmed.
9
5
1
➃ To toggle between full and programmed scan, push [SET].
➄ To stop the scan, push [(V/MHz)
SCAN].
Ä Push [VFO] to select VFO mode for full/pro-
grammed scan; or push [MR] to select memory
mode for memory scan.
Å Set the squelch to the point where noise is just
muted.
Ç Push [➁SCAN] to start the scan.
• [Y]/[Z] also start the scan when pushed and held.
É Push [SET] to toggle between full and pro-
grammed scan.
Ñ To stop the scan push [
➂SCAN].
SCAN
2
SET
B
During memory scan
M
9
5
1