46
12
POCKET BEEP AND TONE SQUELCH
■ Pocket beep operation
This function uses subaudible tones for calling and can be
used as a “common pager” to inform you that someone has
called while you were away from the transceiver.
D Waiting for a call from a specific station
➀ Set the operating frequency.
➁ Program the subaudible tone frequency in set mode.
• See p. 23 for programming details.
➂ Push [TONE] one or more times to indicate “T SQLS”
in the function display.
➃ When a signal with the correct tone is received, the trans-
ceiver emits beep tones and flashes “S”.
• Beep tones sound for 30 sec and “S” flashes. To stop the
beeps and flashing manually, push any key. When the beep
tones are not stopped manually, “S” continues flashing until
step ➄.
➄ Push [PTT] to answer.
➅ Push [TONE] once or twice to cancel the function.
Ä Set the operating frequency.
Å Program the subaudible tone frequency in set
mode.
• See p. 23 for programming details.
Ç Push [FUNC] then [➇T SQLS] to turn the
pocket beep ON.
É When a signal with the correct tone is received,
the transceiver emits beep tones for 30 sec. and
flashes “S”.
Ñ Push [PTT] to answer or push [ECLR] to stop
the beeps and flashing.
• Tone squelch is automatically selected.
• Pushing [FUNC] then [➈TSQL] also selects the tone
squelch.
Ö To cancel the function, push [FUNC] then [GT-
OFF].
D Calling a waiting station using pocket beep
A subaudible tone matched with the station’s frequency is
necessary. Use the tone squelch on the next page or a sub-
audible tone encoder (pgs. 23, 47)
To Next Page
Loading...
