Icom IC-2100H

57
14
OTHER FUNCTIONS
■ Microphone [F-1]/[F-2] keys
Switches on the transceiver’s front panel can be assigned to
the microphone’s [F-1] and [F-2] keys.
➀ Turn power OFF.
➁ While pushing the desired switch on the transceiver and
[F-1] or [F-2] on the microphone, turn power ON.
• The function is programmed into the key ([F-1] or [F-2]).
• Default setting
The following functions are assigned to the [F-1]/[F-2] keys
when first applying power or after CPU resetting.
[F-1]: selects output power; push and hold to select duplex
setting
[F-2]: selects a tone function or none at all; push and hold to
start tone scan, push again to stop tone scan.
☞ NOTE: [F-1] and [F-2] key assignment is available for the
HM-98S
HAND MICROPHONE only.
■ Demonstration
display
A demonstration function is available at power ON. This func-
tion gives you a quick visual introduction to the function dis-
play indicators.
➀ While pushing [T-SCAN] (3rd switch from right), push
[PWR] to turn power ON.
• The transceiver cycles through a visual tour of the function dis-
play indicators.
➁ Push any switch to exit demonstration mode and enter the
normal operating condition temporarily.
☞ NOTE: The transceiver automatically returns to demon-
stration mode after 2 min. in which no operations are per-
formed. To deactivate the demonstration display
permanently, turn power OFF, then while pushing [T-
SCAN], turn power ON again.
AT
POWER ON