EasyManua.ls Logo

Icom IC-2720H - I Microphone Keys

Icom IC-2720H
96 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
66
11
OTHER FUNCTIONS
New2001
11
Microphone keys
The supplied HM-133s (optional for some versions) [F-1] and
[F-2] keys memorize the transceiver conditions.
The [UP]/[DN] keys of the standard or an optional microphone
(other than the HM-133) can be assigned functions like the
function keys on the transceivers front panel.
DD
[UP]/[DN] keys on a microphones
(other than HM-133)
The following functions are assigned to the [UP]/[DN] keys on
the other microphones (HM-118N/TAN, etc.) when rst apply-
ing power.
Default setting
[UP] : channel up; push and hold to start scan, push again
to stop scan.
[DN] : channel down; push and hold to start scan, push
again to stop scan.
Assigning a function
q Turn the power OFF.
w While pushing the desired switch on the transceiver and
one of either [UP]/[DN] keys on the microphone, turn the
power ON.
The function is programmed into the key.
Clearing an assignment
q Turn the power OFF.
w While pushing the desired [UP] or [DN] key on the micro-
phone, turn the power ON.
DD
[F-1]/[F-2] keys on HM-133
The following conditions in the main band or both left and
right bands can be memorized into [F-1] and [F-2] keys, in-
dependently.
Operating frequency
Repeater setting
(offset direction and frequency, tone ON/OFF
and frequency)
Tone/DTCS squelch (ON/OFF, frequency/code and polarity)
Transmit output power selection
Tuning step
Operating mode selection (FM/AM)
Set mode settings*
Initial set mode settings*
*
Only when storing both bands conditions
Programming the both bands condition
After setting the desired contents of each
condition in the both bands, push [FUNC]
then push [F-1]/[F-2] for 1 sec.
3 beeps sound.
Recalling the both bands condition
Push [FUNC] then [F-1]/[F-2] momentarily.
Programming the main band condition
Set the desired contents of each condition in
the main band, then push [F-1]/[F-2] for 1 sec.
3 beeps sound.
Recalling the main band condition
Push [F-1]/[F-2] momentarily.
[F-1]/[F-2]
AT
POWER ON
IC-2720H_2.qxd 03.5.13 9:45 Page 66 (1,1)

Table of Contents

Other manuals for Icom IC-2720H

Related product manuals