67
11 OTHER FUNCTIONS
New2001
■ Partial reset
If you want to initialize the operating conditions (VFO fre-
quency, VFO settings, set mode contents) without clearing
the memory contents, a partial resetting function is available
for the transceiver left and right bands independently.
➥ While pushing desired band’s [V/MHz•SCAN], turn the
power ON to partially reset the desired band (left or right).
✔
Hint!
When pushing both [V/MHz•SCAN] and turning the power
ON, partially reset both bands at the same time.
■ ALL reset
The function display may occasionally display erroneous in-
formation (e.g. when first applying power). This may be
caused externally by static electricity or by other factors.
If this problem occurs, turn power OFF. After waiting a few
seconds, turn power ON again. If the problem persists, per-
form the following procedure.
• Partial resetting is also available. See left for details.
IMPORTANT!:
Resetting the transceiver CLEARS all memory information
and initializes all values in the transceiver.
➥ While pushing both band’s [M/CALL•MW], turn the power
ON to reset the CPU.
[M/CALL•MW]
While pushing both [M/CALL•MW], turn power ON.
[M/CALL•MW]
AT
POWER ON
Left band partial reset.
Right band partial reset.
AT
POWER ON
IC-2720H_2.qxd 03.5.13 9:45 Page 67 (1,1)
To Next Page
Loading...
