34
5
RECEIVE AND TRANSMIT
■ RIT and
∂∂
TX
•RIT function
The RIT function shifts the receive frequency up to
±9.999 kHz in 1 Hz steps (10 Hz steps when can-
celling the 1 Hz step readout) without moving the
transmit frequency.
•See #2 on p. 6 for function description.
q Push the [RIT] switch.
w Rotate the [RIT/∂TX] control.
e To reset the RIT frequency, push [CLEAR] for
1 sec.
•Push [CLEAR] momentarily to reset the RIT frequency
when the quick RIT/∂TX clear function is ON. (p. 72)
r To cancel the RIT function, push [RIT] again.
•“ ” disappears.
•
∂∂
TX function
The ∂TX function shifts the transmit frequency up to
±9.999 kHz in 1 Hz steps (10 Hz steps when can-
celling the 1 Hz step readout) without moving the re-
ceive frequency.
•See #3 on p. 6 for function description.
q Push the [∂TX] switch.
w Rotate the [RIT/∂TX] control.
e To reset the ∂TX frequency, push [CLEAR] for
1 sec.
•Push [CLEAR] momentarily to reset the RIT frequency
when the quick RIT/∂TX clear function is ON. (p. 72)
r To cancel the ∂TX function, push [∂TX] again.
•“ ” disappears.
When RIT and ∂TX are ON at the same time, the [RIT/∂TX] control shifts both the
transmit and receive frequencies from the displayed frequency at the same time.
•Calculate function
The shift frequency of the RIT or ∂TX function can
be added/subtracted to the displayed frequency.
While displaying the RIT and/or ∂TX shift frequency,
push [RIT] or [∂TX] for 1 sec.
•Practical example
When you find a DX station on 21.025 MHz/CW and
the station is picking up stations transmitting slightly
up from 21.025 MHz.
q Push [RIT] and [∂TX] to turn both the RIT and
∂TX functions ON.
w Rotate [RIT/∂TX] to find the DX station’s receive
frequency.
e When you find the DX station’s receive frequency,
push [RIT] to turn the RIT function OFF.
•Now you can transmit the DX station’s receive fre-
quency and receive the DX station’s transmit fre-
quency (21.025 MHz).
r Start transmitting while the station is standing by.
To Next Page
Loading...
