3
1
PANEL DESCRIPTION
D KEYPAD (Available with IC-A15 only)
Inputs digit “1” for frequency input or memory
channel selection, etc. (pgs. 8, 12)
Inputs “1,” “Q,” or “Z” during memory name pro-
gramming.
(p. 15)
After pushing [FUNC], turns the ANL (Automatic
Noise Limiter) function ON and OFF. (p. 21)
Inputs digit “2” for frequency input or memory
channel selection, etc. (pgs. 8, 12)
Inputs “2,” “A,” “B,” or “C” during memory name
programming.
(p. 15)
After pushing [FUNC], starts the scan. (pgs. 18,
19)
Inputs digit “3” for frequency input or memory
channel selection, etc. (pgs. 8, 12)
Inputs “3,” “D,” “E,” or “F” during memory name
programming.
(p. 15)
After pushing [FUNC], selects memory bank
mode, during memory mode. (p. 12)
Inputs digit “4” for frequency input or memory
channel selection, etc. (pgs. 8, 12)
Inputs “4,” “G,” “H,” or “I” during memory name
programming.
(p. 15)
Inputs digit “5” for frequency input or memory
channel selection, etc. (pgs. 8, 12)
Inputs “5,” “J,” “K,” or “L” during memory name
programming.
(p. 15)
Inputs digit “6” for frequency input or memory
channel selection, etc. (pgs. 8, 12)
Inputs “6,” “M,” “N,” or “O” during memory name
programming.
(p. 15)
Inputs digit “7” for frequency input or memory
channel selection, etc. (pgs. 8, 12)
Inputs “7,” “P,” “R,” or “S” during memory name
programming.
(p. 15)
Inputs digit “8” for frequency input or memory
channel selection, etc. (pgs. 8, 12)
Inputs “8,” “T,” “U,” or “V” during memory name
programming.
(p. 15)
After pushing [FUNC], key touch beep output ON
and OFF. (p. 21)
To Next Page
Loading...
Need help?
General
