Icom IC-M323 - Page 52

42
7
DSC OPERATION
■ Making DSC calls
Making a Test call (continued) D
Push [CALL] to make a Test call. r
 •IfChannel70isbusy,thetransceiverstandsbyuntilthechannel
becomes clear.
After the Test call has been transmitted, the following t
screen is displayed.
When the acknowledgement call is received, alarm sounds y
and the following screen is displayed.
Push [ALARM OFF] to stop the alarm, and then the screen u
as shown below is displayed.
Push [EXIT] to return to the normal operating mode. i