Icom IC-M323 - Making a Distress Relay Call;Distress Relay Acknowledgement

43
7
DSC OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Making a D Test Acknowledgement call
When the “TEST ACK” in DSC settings is set to ‘Auto TX’
(p. 62), the transceiver automatically transmits a reply call
when a Test call is received.
Quick ACK:
When a Test call is received, alarm sounds and the screen q
shown below is displayed.
Push [ALARM OFF] to stop the alarm.
Push [ACK]. w
 •Push[EXIT]toreturntothenormaloperatingmode.
 •Push[INFO]todisplaytheTestcallinformation.
About Received call information:
•Push[EXIT]toreturntothenormaloperatingmode.
•Push[BACK]toreturntothepreviousscreen.
•Push[ACK]togotothenextstep.
The Test ACK confirmation screen is displayed. e
Push [CALL] to make an acknowledgement call.
While transmitting the acknowledgement call, the screen r
shown below is displayed, and then returns to the normal
operating mode.
+ Continued on the next page.