Icom IC-M323

47
7
DSC OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
When no GPS receiver is connected and built-in GPS re-
ceiver* is not receiving valid position data, and both position
and time have been manually entered, the screen as shown
below is displayed. Edit your latitude and longitude position
and UTC time as follows:
*For only IC-M323G and IC-M324G.
Push [CHG], then edit your latitude and longitude posi- ➥
tion and UTC time.
 •SelectadesirednumberusingDial,or[Y]/[Z]/[Ω]/[≈].
 •Push[ENT]orDialtosetit.
 •Tomovethecursor,selecteitherarrow,“←” or “→,” then push
[ENT] or Dial.
 •SelectN(Northlatitude)orS(Southlatitude)whenthecursor
is on the ‘N’ or ‘S’ position.
 •SelectW(Westlongitude)orE(Eastlongitude)whenthecur-
sor is on the ‘W’ or ‘E’ position.