Icom IC-M88 - Call Channel Programming and Lock Function

■ Call channel programming
ThecallchannelkeyisusedtoselectChannel9bydefault,
however, you can program your most often-used channels in
eachchannelgroupforquickrecall.
q Push[CH/WX•
U/I/C/L]for1sec.
several times to select the de-
siredchannelgroup(USA,INT,
CAN)tobeprogrammed.
wPush [16•
9]for1 sec.to select
the call channel.
 •“CALL”andcallchannelnumberap-
pear.
ePush[16•9]againfor3sec.(until
alongbeepchangesto2short
beeps)toentercallchannelpro-
gramming condition.
 •Call channel number to be pro-
grammed flashes.
r Push [Y]/[Z] to select the de-
sired channel.
tPush[16•
9] to program the dis-
played channel as the call chan-
nel.
 •Thecallchannelnumberstopash-
ing.
■ Lock function
Thisfunctionelectronicallylocksallkeys(exceptfor[PTT],
[SQL]and[H/L•
LOCK])topreventaccidentalchannelchanges
and function access.
•Push[H/L•LOCK]for1sec.toturnthelockfunctionONandOFF.
Appearswhilethe
lock function is used.
12
4
BASICOPERATION