Icom IC-M88

D Charging connections
q Attach the BC-152Nto a at surface, such as desk or
cabin, etc., if desired.
w ConnecttheACadapterasshownbelow.
e Insert the battery pack with/without the transceiver into the
charger.
 •Thechargeindicatorlightsorange.
r Chargethebatterypackapproximately10hours,depend-
ing on the remaining power condition.
 •Thechargeindicatorlightsgreenwhenchargingiscompleted.
BC-152N
Supplied screws
Ensure sides of the
battery pack are
correctly aligned
with the guide rails.
Battery pack
Transceiver
AC adapter
(A different type, or no AC adapter is supplied,
depending on the version.)
Tu rn power OFF
Charge
indicator lights
orange while
charging.
❍ Charging indicator:
•Lightsorangewhilecharging.
•Lightsgreenwhenchargingiscompleted.
•Blinksorangeorgreen,ordoesnotlightwhenaproblemsis
detected.
SOLUTIONS:
•Removethebatterypack,andreinsertit.
•Removethebatterypack,cleanthebatteryterminals,
then reinsert it.
•Ifthebatterypacktemperatureishigh,removeandlet
it cool down, then reinsert it.
If you are unable to solve the problem through the use of
these solutions, the battery pack or the charger may be
damaged, or the battery life may be over. In that case,
contact your nearest Icom Dealer or Service Center.
NOTE: Afterchargingiscompleted,theBC-152Nwillauto-
matically recharge the battery pack when the battery volt-
age decreases. If the battery pack is often left in the char-
ger for long periods, the battery life cycle will be shorter.
D For your convenience
23
9
BATTERYCHARGING
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Eyelet
USE a rubber
band to secure
the transceiver
while charging,
if desired.