127
14
OPTIONAL UNIT INSTALLATION
14
rConnect P1 (4 pin) of the UT-106 to J16 of the LOGIC
board.
tConnect the supplied flat cable between J3 of the UT-106
and J15 of the LOGIC board.
• Be sure not upside down.
yRemove the protective paper from the supplied velcro
®
,
then attach it to the UT-106 and the shield case of MAIN
board.
uReplace the top cover, cables and screws to the original
position.
Velcro
®
is a registered trademark of Velcro Industries B.V.
To Next Page
Loading...
