VI
QUICK REFERENCE GUIDE
New2001
DD
Starting scan
1. Select VFO mode.
Push [V/M•S.MW•~] to select the VFO mode for full, band
and programmed scan operation.
• Select memory mode by pushing [V/M•S.MW•~] again for mem-
ory or bank scan.
2. Selecting a scanning type
Push [MODE•SCAN] for 1 sec.,
then rotate [DIAL] to select
one of the desired scanning type.
• Available scan types when VFO mode is selected; “ALL” for full
scan; “BAND” for the selected band; one of “PROGxx” (xx=0 to 24)
for programmed scan.
• Available scan types when memory bank is selected; “ALL” for all
bank scan; “BANK” for the selected bank scan.
3. Starting scan
Push [MODE•SCAN] to start scan.
• Rotate [DIAL] to change the scanning direction.
4. Cancelling scan
Push [MODE•SCAN] again to stop scan.
✔
For your information
The memory channel number you program the scan edges
into correlate “PROGxx” as follows:
00A/00B: Scans between frequencies programmed in 00A
and 00B channels, and select “PROG 00”
01A/01B: Scans between frequencies programmed in 01A
and 01B channels, and select “PROG 01”
•
•
•
•
23A/23B: Scans between frequencies programmed in 23A
and 23B channels, and select “PROG 23”
24A/24B: Scans between frequencies programmed in 24A
and 24B channels, and select “PROG 24”
To Next Page
Loading...
