Icom IC-R5 - I DTCS Polarity Setting

37
8 TONE SQUELCH AND POCKET BEEP
New2001
■ DTCS polarity setting
As well as the code setting, the polarity setting is also avail-
able for the DTCS operation. When a different polarity is set,
the DTCS never releases audio mute even a signal with
matched code number is received.
qPush [TS•SET] for 1 sec. to enter set mode.
wRotate [DIAL] to select “EXPAND” item.
eWhile pushing [FUNC], rotate [DIAL] to turn the expanded
set mode ON.
rRotate [DIAL] to select “DTCS P” item.
tWhile pushing [FUNC], rotate [DIAL] to select the polarity
from normal (NORMAL) and reverse (REV).
yPush [TS•SET] to exit set mode.
Normal polarity Reverse polarity
After 1 sec.
[TS•SET]
[FUNC]
[DIAL]
IC-R5_1.qxd 02.10.23 11:29 Page 37 (1,1)