D-STAR 操作
57
D-STAR GUIDE
■ 发起一个网关 CQ 呼叫
当在
“TO”（目的地）中选择了目的地中继器时，您可以进行网关 CQ 呼叫。
What is a Gateway CQ call?
• To call a CQ through a repeater connected to the Internet.
• You can call a CQ to the areas where you cannot directly access because the
communication is routed through the Internet.
Step 1: Set “FROM” (Access repeater).
Same as described in page 56.
Step 2: Set “TO” (Destination).
1. Push D-pad() to select “TO,” and then push [ENT].
2. Select “Gateway CQ.”
3. Select the repeater group where your destination repeater is listed.
4. Select your destination repeater.
• Returns to the DR screen, and the selected repeater name is displayed in “TO.”
Step 3: Hold down [PTT] to transmit.
1. Hold down [PTT] to transmit.
• The TX/RX indicator lights red while transmitting.
2. Release [PTT] to receive.
NOTE: If the selected Access repeater does not connect to the gateway, “ ” is
displayed. In that case, you cannot select “Gateway CQ.”
To Next Page
Loading...
