ICS Nav6 User Manual

Page 15
Message Categories
The picture shows the 518 Types filter page;
the 490 Types filter page is similar.
Each of the message types can be selected as
either On, Off or New
Use the UP and DOWN keys to select the
message type setting that you wish to edit. Use
the LEFT and RIGHT keys to change the
setting.
Set each message type filter to one of the
following:
Setting Notes
On Message type always
displayed
Off Message type never
displayed
New Message type only
displayed when new.
Messages marked as
read will not appear.
Stations
The picture shows the 518 Stations filter page;
the 490 Stations filter page is similar. Use the
UP and DOWN keys to select the station filter
setting that you wish to edit. Use the LEFT and
RIGHT keys to change the setting.
The ‘Auto Station Filter’ setting can be either
Nearest or In Range. This setting is active only
when you have a GPS receiver connected to
the NMEA input and it applies only to stations
set to Auto. To display messages from the
nearest station to your current position, set the
auto station filter to Nearest.
To display messages from all stations in range
of your current position, set the auto station
filter to In Range.
An asterisk appears next to all stations for
which messages will be displayed.

ICS Nav6 Specifications

Power

voltage range	10.8V to 15.6V
standby power consumption	1.5 W at 12V
printing power consumption	2.5 W at 12V

Operating Environment

operating temperature range	0 to +40°C
storage temperature range	-20 to +55°C
humidity	0 to 95%

Weight and Dimensions

weight without cable	1200 g
paper roll width	80mm
paper roll length	20m