ICT KT-LCD7C - Motor operating temperature alarm; General Project Setting; Maximum Trip Speed; P Parameter Setting

ELECTRIC BICYCLE METER KT—LCD7C Product User Manual
- 12 -
automatically display (flicker) fault code. You can’t exit the fault code display only the
fault is removed.
Error Code Display
Error Code & Definition Table：
Error Code
Definition
Motor position sensor fault!
illegal signal for hall sensor
Motor or controller short circuit fault!
there is a short-circuit fault occur
THROTTLE fault!
illegal signal for throttle
Motor operating temperature alarm：
Under any interface, when the motor operating temperature exceeds the warning value,
the motor operating temperature display flashes to alarm, meanwhile, the controller will
offer the appropriate protection to motor.
User Setting Project
KT-LCD7C meter user setting project：
◇ General project setting
◇ P parameter setting
◇ C parameter setting
◇ L parameter setting
General Project Setting
○ Maximum Trip Speed
Under power off status, hold button long (SW), the meter is turned on. Within
5 seconds after boot-up, hold button (UP) and button (DOWN)
simultaneously for about 2 seconds, the first is to enter the maximum riding speed setting