ICT KT-LCD7C - L2 Parameter setting; L3 Parameter setting; L4 parameter setting

ELECTRIC BICYCLE METER KT—LCD7C Product User Manual
- 33 -
When L2=0, P1 parameter is set as the calculated value.
When L2=1, P1 parameter is set as a half of the calculated value.
After finishing L2 parameter setting, press button (SW) to save the current
value and then enter L3 parameter setting interface.
○ L3 Parameter setting
L3 parameter is applicable to the dual mode controller. The default of the factory
is 1.
When L3=0, the controller will activate Non-Hall model only when the Hall
sensor in the motor fails
When L3=1, the controller will choose the proper model to use according to
the controller system optimization.
After finishing L3 parameter setting, press button (SW) to return to parameter
setting interface.
○ L4 parameter setting
Under parameter setting interface, move cursor to L4 and press button shortly (SW), the value
flashes
L4 parameter is used to adjust the delay time of automatic shutdown of the LCD, the
default value is 5, and the range of adjust is 5-120 minutes.