C12 default value is 4, namely, controller minimum operating voltage (voltage
shortage value); when setting is 5, the default value plus 0.5V, when setting is 4, the
default value minus 0.5Vand so on.
After finishing C12 parameter setting, press button (SW) to save the current set
values and enter C13 parameter setting interface.
○ C13 ABS brakes of the controller and parameters of anti-charge control Setting
Enter into C13 parameter setting interface, C13 parameter bar flashes.
C13 parameter setting interface
C13 is ABS brakes of the controller and parameters of anti-charge control setting, the
default value is 0 with the setting range between 0-5, press (UP) button or
(DOWN) button to make selection.
To Next Page
Loading...