ICT KT-LCD7C - C15 Push-assist Speed Parameters Setting

ELECTRIC BICYCLE METER KT—LCD7C Product User Manual
- 31 -
C14 parameter definition table:
C14 Value
Assist strength of intelligent pedal motor
1
Weak assist strength of motor
2
General assist strength of motor
3
Stronger assist strength of motor
After finishing C14 parameter setting, hold button (SW) shortly to save the
current set values and enter C15 parameter setting interface.
○ C15 Push-assist Speed Parameters Setting
Enter C15 parameters setting interface, C15 flashes.
C15 is the setting of push-assist speed, default value is 6, range from 4-6, press (UP)
button or (DOWN) button to choose
C15 parameters
C15valte
Push-assist speed
4
4Km/H
5
5Km/H
6
6Km/H
After finishing C15 parameter setting, hold button (SW) shortly to save current set
values and enter C1 parameter setting interface again. Or hold button (SW) long for
about 2 seconds to exit C parameter setting environment and return to the display 1.
○ Exit Parameter Setting
Under each parameter setting interface, if there’s no button operation on the meter for