Remote operation
The X2i will allow you to check your messages remotely
from another phone. To use this function you must call
using a tone dialling telephone and you will need to
enter your X2i’s master PIN.
The remote control function must be activated before it
can be used, and will not function unless the master PIN
has been changed from the default (see page 45).
To activate
remote
control:
1 Press the MENU/OK button ONCE then á
ONCE
è
Display Shows Main Menu >Ans Machine
2 Press the MENU/OK button ONCE then á
ONCE
è
Display Shows Ans. Machine >Settings
3 Press the MENU/OK button ONCE then á
TWICE
è
Display Shows Ans Settings >Remote Access
4 Press the MENU/OK button
è
Display Shows Remote Access >Deactivated
5 Press the â button to select between
Activated and Deactivated
è
Display Shows Remote Access >Activated
6 Press the MENU/OK button to confirm the
selection
è
You will hear a confirmation beep
7 Use the CANCEL button to exit the menu or
press and hold HANG UP to go to standby
mode
Remote operation
Help Line: 0845 345 9677 (Local Call rate) 37
To Next Page
Loading...
