Contents
Read these notes first 4
Choosing a site for the base unit and
charger pod 4
Radio signals between handset and
base unit 4
Mains power connection 4
Installation and set-up 5
Before you start 8
Electrical safety 8
Interference 8
‘Out of range’ warning 8
Switching on and off 9
To lock the keypad 9
Your handset’s name 10
Time and day 11
Ringer volume and melody 12
Making and answering calls 14
Using the speakerphone 14
To make a call 14
To answer a call 14
To end a call 14
Earpiece volume 15
To mute the mouthpiece 15
Last Number Redial (LNR) 15
To delete redial numbers 16
To store a Redial number in the
Phone Book 17
Using the Phone Book 18
To store a new number 18
To call a stored number 19
To delete all Phone Book entries 21
Caller Display 22
To check Caller Display records 23
To return a call 23
To store a Caller Display number in
the Phone Book 23
To delete a caller display record 24
To delete all caller display records 24
Using a multi-handset system 25
To make an intercom call 25
To end an intercom call 25
To answer an intercom call 26
To transfer a call 26
To shuttle between two calls 27
To set up a three-way conference 27
To end the conference 27
New Call tone 28
To page all handsets from the
base unit 28
Answering machine setup 29
X2i answering modes 29
To change answering mode: 29
The outgoing message 30
To record a new outgoing message:
30
Setting the ring delay 31
Call Screening 32
To switch call screening on: 32
Answering machine operation 33
2
To Next Page
Loading...
