Registering new handsets
The handset(s) supplied with your iDECT X2i base unit
are already registered to it, so you don’t need to
register them. But if you’ve bought extra handsets
separately, you’ll need to register them. Each iDECT X2i
base unit can be registered to up to four handsets.
To register a
new handset
Make sure the handset you’re registering is in
standby mode.
1 Press the MENU/OK button
è
Display shows Main Menu >Phonebook
2 Press the â button THREE times
è
Display shows Main Menu >Advanced Set
3 Press the MENU/OK button
è
Display shows Advanced Set >Recall Time
4 Press the â button TWICE
è
Display shows Advance Set >Registration
5 Press the MENU/OK button
è
The display shows Enter PIN.
The PIN is 0000 unless you’ve set a new one
(see page ).
6 Key in the PIN and press the MENU/OK
button
è
The display shows Registering
7 Immediately press the HANDSET LOCATOR
button on the base unit and hold it until you
hear a tone
è
If the base is found and the PIN is correct you
will hear a long confirmation beep. The handset
is automatically given the lowest free handset
number.
Registering new handsets
56
To Next Page
Loading...
