(C) IDM ENERGIESYSTEME GMBH
Installation instructions iPump A 2-7, 3-11
3
Contents
All rights reserved for modifi cations to the technology and design!
6.7. Assembling of the outdoor unit on the concrete base 39
6.8. Earthing of the heat pump system 39
6.9. Condensation run-off 40
6.10. Connection of the condensation run-off 40
6.11. Minimum distances 40
7. CONNECTION OF THE REFRIGERANT CIRCUIT 41
7.1. Connection lines of the refrigerant circuit 41
7.2. Connection of the outdoor unit on refrigerant side 41
7.3. Connection of the indoor unit on refrigerant side 42
7.4. Wall opening 43
7.5. Installation of the refrigerant connection pipes 43
7.6. Important information about the installation of the refrigerant pipes 43
8. ELECTRICAL ASSEMBLY 44
8.1. Electrical power supply 44
8.2. Electrical connection indoor unit 44
8.3. Electrical connection indoor unit 44
8.4. Electrical connection of the outdoor unit 45
8.5. Connection diagram of the electrical module 46
8.6. Connection of the central unit 47
9. COMMISSIONING 48
9.1. Notes for commissioning 48
9.2. Appliance and operation 48
9.3. Faults 48
10. MAGNESIUM PROTECTION ANODE 49
10.1. General 49
10.2. Testing the magnesium protection anode 49
10.3. Exchange of the magnesium protection anode 50
10.4. Installing an external current anode 51
11. HYDRAULIC DIAGRAMS 52
11.1. iPump A with direct circuit for heating and hot water circulation 52
11.2. iPump A with direct heating circuit, hot water circulation and one mixer heating circuit 53
12. HEATING SIDE INSTALLATION 54
13. D
ECLARATION OF CONFIRMITY, PRODUCT FICHE 55
14. T
ECHNICAL DOCUMENTATION 58
To Next Page
Loading...
