RECHARGE THE INTERNAL BATTERIES of the 89 mm TITANIUM HOUSING
The rechargeable battery pack can be different from probe to probe. The battery pack comes complete
with the associated international battery charger. The below
instruction are valid for each battery pack
1) Dry the probe and lay it down on a table.
2) Remove the four titanium fixing bolts on the probe cover with
the hexagonal wrench included in the probe accessories.
3) In case the cover does not come out easily, screw the four bolts
(previously removed) into the blind holes in order to extract the
probe cover. Gradually screw the bolts alternating between
them such as to raise the cover evenly.
4) When extracting the cover, dry the fissure between the cover
and the body of probe with a strip of paper inserted edgewise
and dry any trace of water in the proximity of the external side
of the o-ring.
5) Pull the battery pack off and remove the cable connector.
6) Connecting the battery pack, the charger immediately checks
the nominal voltage, thus automatically selecting the most
appropriate action to carry out.
LED indicators
Please carefully read the booklet associated to the battery pack
for detailed instruction about the indication during the battery
charging.
Note
At the end of the quick-charging procedure, the charger undertakes a
low-current equilibration charging procedure which lasts 30 m. This
procedure is also called tricky-charging procedure. The aim of this
procedure is to keep the battery cells in good condition, thus
compensating for the auto-discharge.
7) Replace the cover on the probe and lift the probe itself vertically.
8) Close again the probe with the four bolts. Gradually tighten the
bolts in sequence such as to close the cover uniformly.
To Next Page
Loading...
