8.2 How to Enter the User Program Mode
1. Ensure that the panel is not armed.
2. Hold down the [*] key until the keypad buzzer sounds.
3. The LCD display reads „Master Code + *‟. The factory default is [1234]. Should the MASTER
USER CODE be set to six digits it will be [123456] by default.
4. Enter the [MASTER USER CODE], followed by the [*] key. A valid entry will be confirmed by a
long beep. If an invalid MASTER USER CODE was entered, the keypad buzzer will give an error
beep (3 short beeps).
5. The first menu option – „Option Menu‟, „Add User Code‟ is displayed by default.
6. Select a programmable option from Table 1. One may use the [PANIC] or [MED] keys to scroll
through the menu options.
7. Confirm the entry by pressing the [*] key. A valid entry is confirmed by a long beep. An invalid
entry will be signalled by means of an error beep (3 short beeps). If an error beep occurs, press
the [#] key to clear all previous entries, and repeat steps 2 – 6.
EXAMPLE:
To add a new user code, enter User Program Mode by completing steps 2 - 4 as listed above. Menu
Option 0 will be displayed on the LCD screen by default. Press the [*] key to confirm your entry. Once
prompted to „Enter a User Code‟, input a [NEW USER CODE] followed by the [*] key. Once the user
code is programmed, enter the next code followed by [*]. To exit the program mode press the [#] key.
For a full list of options, refer to Table 1. Programming of these options is explained below.
8.3 Explanation of Programmable Options
8.3.1 Option 0 - Add a New User Code
[*] [MASTER CODE] [*] [0] [*] [NEW CODE] [*] [#]
1. Enter the User Program Mode as per steps 1 - 4 of section 8.2.
2. The LCD display reads „Option Menu‟, „Add User Code‟. As this is the programmable option you
require, press the [*] key.
3. The LCD display reads „New Code + *‟.
4. Enter [NEW USER CODE] followed by the [*] key.
5. A valid entry is confirmed by a long beep. An invalid entry will be signalled by means of an error
beep (3 short beeps). If an error beep occurs, press the [#] key to clear all previous entries and
repeat steps 1-4.
6. Further codes can be added by repeating step 4 above. When a user code is added, it is stored
in the first available user slot.
7. Press the [#] key to exit the User Program Mode.
8.3.2 Option 1 - Edit a Selected User Code
[*] [MASTER CODE] [*] [1] [*] [OLD CODE] [*] [NEW CODE] [*] [#]
1. Enter the User Program Mode as per steps 1 - 4 of section 8.2.
2. The LCD display reads „Option Menu‟, „Add User Code‟.
To Next Page
Loading...
