[0] [*] Copy All – this is used to update the zone names to all keypads connected to the X-
series Alarm Panel. This is used when a keypad has been replaced or a new keypad is
added to the panel. (This can be used when you replace a keypad and want it to display
the existing zone names).
[111] [*] Delete Name – this is used to delete the zone name being viewed from the X-series
Alarm Panel.
[222] [*] Delete All – this option is used to delete all zone names from the X-series Alarm Panel.
8.3.13 Option 40 - Edit the Time
[*] [MASTER CODE] [*] [4] [0] [*] [TIME] [*] [#]
1. Enter the User Program Mode as per steps 1 - 4 of section 8.2.
2. The LCD display reads „Option Menu‟, „Add User Code‟.
3. To select menu option 40 – „Edit Time‟, press the [4] [0] keys followed by the [*] key or
alternatively use the [PANIC] or [MED] keys to scroll through the list of programmable options
until you reach the option you want.
4. Press the [*] key.
5. The LCD display reads „New Time?‟.
6. Enter the [TIME] that you wish to edit, followed by the [*] key. The format is HHMM.
7. Press the [#] key to exit the User Program Mode.
8.3.14 Option 41 - Edit the Date
[*] [MASTER CODE] [*] [4] [1] [*] [DATE] [*] [#]
1. Enter the User Program Mode as per steps 1 - 4 of section 8.2.
2. The LCD display reads „Option Menu‟, „Add User Code‟.
3. To select menu option 41 – „Edit Date‟, press the [4] [1] keys followed by the [*] key or
alternatively use the [PANIC] or [MED] keys to scroll through the list of programmable options
until you reach the option you want.
4. Press the [*] key.
5. The LCD display reads „New Date?‟
6. Enter the [DATE] that you wish to edit, followed by the [*] key. The format is DDMMYY.
7. Press the [#] key to exit the User Program Mode.
9. Stay Zones
Stay zones are those zones that are bypassed automatically when the system is "STAY ARMED". To avoid
triggering the alarm, zones such as bedrooms that are protected by Passive Infra-Red (PIR) detectors or
windows that may be opened, must be bypassed when "staying at home". Stay zones need only be
programmed once. Each time the system is armed in the Stay Mode the pre-selected stay zones will be
bypassed automatically. The panel allows for four unique STAY PROFILES to be stored. A STAY PROFILE
stores a preselected combination of STAY and BUZZ zones to suit a specific STAY ARM requirement. If a
partition is stay armed using Profile 1, it is possible to toggle the panel arm status directly to stay arm
profile 2 by holding the [5] key for two seconds. STAY and BUZZ zones can be programmed for each
profile once the profile has been selected. See sections 9 & 10.
To Next Page
Loading...
