IDS X Series - Option 2 - Delete User Code (Code Known); Option 3 - Add;Edit Code; Option 4 - Delete a User Code (Slot Known)

Section: 8
IDS X-series LCD Keypad User Manual 700-411-01D Issued August 2010
16
3. To select menu option 1 – „Edit User Code‟, press the [1] key or alternatively use the [PANIC] or
[MED] keys to scroll through the list of programmable options until you reach the option you
want.
4. Press the [*] key.
5. The LCD display reads „Old Code + *‟.
6. Enter the [USER CODE] you wish to edit followed by the [*] key.
7. The LCD display reads „New Code + *‟.
8. Enter the [NEW CODE] followed by the [*] key. To move the cursor within the NEW CODE, use
the [PANIC] or [MED] keys.
9. To edit other codes repeat steps 5 - 7.
10. Press the [#] key to exit the User Program Mode.
8.3.3 Option 2 - Delete User Code (Code known)
[*] [MASTER CODE] [*] [2] [*] [USER CODE] [*] [#]
1. Enter the User Program Mode as per steps 1 - 4 of section 8.2.
2. The LCD display reads „Option Menu‟, „Add User Code‟.
3. To select menu option 2 – „Delete User Code‟, press the [2] key or alternatively use the [PANIC]
or [MED] keys to scroll through the list of programmable options until you reach Menu Option 2.
Press the [*] key.
4. The LCD display reads „User Code + *‟.
5. Enter the [USER CODE] to be deleted followed by the [*] key. 'Deleting' the code in slot one will
reprogram it to 1234.
6. Further codes may be deleted by repeating step 5.
7. Press the [#] key to exit User Program Mode.
8.3.4 Option 3 – Add/Edit Code
[*] [MASTER CODE] [*] [3] [*] [SLOT NUMBER] [*] [USER CODE] [*] [#]
1. Enter the User Program Mode as per steps 1 - 4 of section 8.2.
2. The LCD display reads „Option Menu‟, „Add User Code‟.
3. To select menu option 3 – „Add/Edit Slot‟, press the [3] key or alternatively use the [PANIC] or
[MED] keys to scroll through the list of programmable options until you reach the option you
want.
4. Press the [*] key.
5. The LCD display reads „Slot + *‟.
6. Enter the [SLOT NUMBER] to be added/edited followed by the [*] key.
7. The LCD display reads „New Code + *‟, „Slot number‟.
8. Enter the [USER CODE] followed by the [*] key.
9. Further slots may be added/edited by repeating steps 6 - 8.
10. Press the [#] key to exit User Program Mode.
8.3.5 Option 4 - Delete a User Code ("Slot" known)
[*] [MASTER CODE] [*] [4] [*] [SLOT NUMBER] [*] [#]
1. Enter the User Program Mode as per steps 1 - 4 of section 8.2.
2. The LCD display reads „Option Menu‟, „Add User Code‟.