IDS X Series - Viewing Trouble Conditions

Section: 12
IDS X-series LCD Keypad User Manual 700-411-01D Issues August 2010
26
12. Viewing Trouble Conditions
(Hold down the [7] key for two seconds until the keypad buzzer sounds)
The user is alerted to a trouble condition via the flashing of the POWER LED. It is also possible to enable
a trouble beep. If the trouble beep has been enabled, the keypad buzzer will sound to alert the user that a
trouble condition has occurred. Press the [#] key to silence the buzzer. Hold down the [7] key for two
seconds. The LCD keypad will display what the trouble conditions are. The system will automatically exit
the TROUBLE VIEWING MODE after one minute. Alternately, to exit this mode, press the [#] key.
NOTE:
Certain trouble conditions will only clear once the trouble condition has restored. To cancel the beeping
without viewing the trouble conditions, press the [#] key.
Table 7: Trouble Conditions
Zone LED
Trouble Condition
1
Panel AC Supply Failure
2
Panel Communications Failure
3
Telephone Line Trouble
4
Siren Tamper
5
Low Battery
6
Aux 12V Resettable Fuse Blown
7
Engineer reset
8
Box tamper
9
Peripheral Device Tamper
10
Peripheral Communications Failure
11
Peripheral Low Supply Voltage
12
EEPROM chip failure
13. Changing a Partition
[MODE] [1] [*] [PARTITION NUMBER] [*]
To change partitions the keypad must be assigned to access the required partition.
1. Hold [MODE] until the keypad beeps.
2. The LCD display reads „Mode Number + *‟.
3. Press the [1] key followed by the [*] key.
4. The LCD display reads „Partition +*‟.
5. Enter the [PARTITION NUMBER], followed by the [*] key.
6. The LCD display reads „P(number)‟.
The keypads may be partitioned to remain in the new partition. Any value outside of these constraints will
result in a key entry error occurring.