IDS X Series - System Operation: Arming and Disarming; Away Arming Procedures; Stay Arming Procedures

Section: 3
IDS X64 LCD Keypad User Manual 700-411-01C Issues August 2010
8
3. Arming the Control Panel
3.1 Away Arming
3.1.1 How to Away Arm
[#] [USER CODE] (Leave via Entry/Exit Zone)
1. Ensure that the LCD display reads „Ready to Arm‟ alongside the partition number being armed. If
not, check that all protected doors and windows are closed and that all movement has ceased in
areas covered by motion detectors. If necessary, bypass any required zones and close the front
door.
2. Press the [#] key.
3. Enter a valid [USER CODE]. If an incorrect code is entered, the keypad buzzer will beep three
times. In the event of an error, press the [#] key and re-enter the code.
4. The ARM LED will come on and the keypad buzzer will sound for the duration of the exit delay.
The LCD display will read „Exit Delay‟ alongside the partition number that is being armed. Any
bypassed zones will be displayed on the LCD display as solid text. Any violated zones will be
displayed on the LCD display as flashing text. To scroll through zones which have been
bypassed or violated use the [PANIC] and [MED] keys.
5. Leave only via a designated exit route. The panel will away arm at the end of the exit delay, if any
enter/exit zone is violated, e.g. the front door.
6. Once the panel has armed, the LCD display will read „Armed‟ alongside the partition that has
been armed.
3.1.2 Quick Away Arm - Shortcut Key
(Hold down the [1] key until the keypad buzzer sounds)
If this function is enabled, it is possible to AWAY arm by simply holding down the [1] key. The LCD
display will read „Exit Delay‟ alongside the partition number being armed. The keypad buzzer sounds and
the arming process begins.
NOTE:
If the partition is already STAY armed, this key will initialize AWAY arming. It is therefore possible to
change directly from STAY armed to AWAY armed.
3.2 Stay Arming
Stay arming allows the user to monitor selected perimeter zones and bypass interior zones. The user can
remain on the premises with access to designated areas during the STAY ARM cycle. Any zone that may
be violated accidentally should be programmed as a buzz zone. When violated, a buzz zone will cause
the keypad buzzer to sound for 30 seconds before sounding the siren. Entering a valid user code before
the siren sounds, prevents an alarm condition from being registered and will silence the keypad buzzer
and prevent the siren from sounding.