14. Output Control via a Keypad
[MODE] [3] [*] [OUTPUT NUMBER] [*] [*] [#]
If the panel has been setup to control switching functions via its outputs, these can be controlled via the
keypad - e.g. turning lights on and off.
1. Hold [MODE] down for one second until the keypad beeps twice.
2. The LCD display reads „Mode Number + *‟.
3. Press the [3] key followed by the [*] key.
4. The LCD display reads „Output Num + *‟.
5. Enter the [OUTPUT NUMBER] followed by the [*] key.
6. Press the [*] key to toggle between ON and OFF.
7. Repeat steps 5 – 6 to program any other outputs.
8. Press the [#] key to exit.
Ensure that you have checked with your Installer which outputs are used for radio reporting to prevent the
triggering of false alarms.
To Next Page
Loading...
