IDTECH SecureMag - 7.3 Reader Reset Command; 7.5 Arm;Disarm to Read Command

Copyright © 2010-2014, International Technologies & Systems Corp. All rights reserved.
Page 17 of 74
SecureMag User Manual
7.1 Get Copyright Information
02 38 03 39
A ‘31-byte’ Copyright Notice will be returned.
Response is as follows:
ACK STX <Copyright String> ETX LRC
Response Example mixed hex and ASCII:
\06\02Copyright (c) 2010, ID TECH \03>
7.2 Version Report Command
02 39 03 38
Response is as follows:
ACK STX<Version String> ETX LRC
Response Example mixed hex and ASCII:
\06\02ID TECH TM3 SecureMag RS232 Reader V 3.19\03\LRC
7.3 Reader Reset Command
02 49 03 48
The reader supports a reset reader command. This allows the host to return the
reader to its default state.
Response is as follows:
06
7.4 OPOS/JPOS Command
There are three forms of the command:
02 4D 01 30 03 7D Enter Standard Mode (Exit OPOS Mode)
02 4D 01 31 03 7C Enter OPOS Mode
02 4D 01 32 03 7F Enter JPOS Mode
Response is as follows:
17 Reader already in OPOS Mode
15 Command failure (wrong length or wrong parameter)
06 Success
7.5 Arm/Disarm to Read Command
Arm to read:
02 50 01 30 03 LRC
This command enables the MSR to be ready for a card swipe in buffered mode.