Copyright © 2010-2014, International Technologies & Systems Corp. All rights reserved.
Page 22 of 74
This option selects the tracks that will be read and decoded.
02 53 13 01 <Track_Selection Settings> 03 LRC
<Track_Selection Settings>
‘0’ Any Track
‘1’ Require Track 1 Only
‘2’ Require Track 2 Only
‘3’ Require Track 1 & Track 2
‘4’ Require Track 3 Only
‘5’ Require Track 1 & Track 3
‘6’ Require Track 2 & Track 3
‘7’ Require All Three Tracks
‘8’ Any Track 1 & 2
‘9’ Any Track 2 & 3
Note: If any of the required multiple tracks fail to read for any reason, no data for
any track will be sent.
7.8.11. Track Separator Selection
This option allows the user to select the character to be used to separate data
decoded by a multiple-track reader.
02 53 17 01 <Track_Separator> 03 LRC
<Track_Separator> is one ASCII Character.
The default value is CR, 0h means no track separator.
7.8.12. Start/End Sentinel and Track 2 Account Number Only
The SecureMag can be set to either send, or not send, the Start/End sentinel, and
to send either the Track 2 account number only, or all the encoded data on Track
2. (The Track 2 account number setting doesn’t affect the output of Track 1 and
Track 3.)
02 53 19 01 <SendOption> 03 LRC
<SendOption>
‘0’ Don’t send start/end sentinel and send all data on Track 2
‘1’ Send start/end sentinel and send all data on Track 2
‘2’ Don’t send start/end sentinel and send account # on Track 2
‘3’ Send start/end sentinel and send account number on Track 2
To Next Page
Loading...
