GB
4 - HANDLING AND INSTALLATION MASTER 880MP E-volution
4 - Pag. 14 / 17
POSITIONING ADJUSTMENTS
After checking alignment of the
feeder with either the thread or the
bar, any required corrections should
be carried out.
Adjust height by turning the (A) and
(B) screws in the support feet;
carry out lateral adjustment with
calibrated mallet blows on the sides
of plates (C).
During this phase, any adjustment
carried out during levelling should
be preserved; therefore, in most
cases, feeder positioning will be the result of a good adjustment compromise.
To Next Page
Loading...
