4 - HANDLING AND INSTALLATION MASTER 880MP E-volution
GB
4 - Pag. 17 / 17
4.7 PNEUMATIC CONNECTION
• Connect pipe (H) to the compressed air
ductwork system as shown in the figure.
CAUTION - PRECAUTION:
to adjust pressure, follow the directions
in section 7.2.3.
4.8 SOFTWARE PARAMETRING
There should be an adequate parametring of the bar feeder software according to the working
needs and to the type of lathe.
For information on this operation, refer to the "Keyboardf panel instruction manual".
To Next Page
Loading...
