GB
5 - ADJUSTMENTS AND SETTING-UP MASTER 880MP E-volution
5 - Pag. 8 / 14
• Remove the lathe spindle liner if
required and install a suitable
liner for the "new" diameter.
• Assemble sleeve (D) of the
"new" diameter and the oil
recovery (C).
• Turn the screw clockwise to
move the feeder body forwards.
CAUTION - PRECAUTION:
bring the body of the
feeder up to the stop on
the tank slowly, thereby
eliminating the risk of
damaging the traverse
unit.
To Next Page
Loading...
