6 - USE AND OPERATION MASTER 880MP E-volution
GB
6 - Pag. 7 / 17
6.4 BAR FEEDER SETUP
This is a list of all the stages of the bar feeder setup, assuming that one wants to start it for
the first time.
• Carry out feeder set-up according to the bar to be machined (paragraph 5.3.)
• Preparing the bars to be processed (section 6.5.).
• Load the bar magazine (paragraph 6.6.).
• Starting the automatic cycle (sections 6.7. and 6.8.).
• Adjust the lubricating oil flow (paragraph 6.9.).
To Next Page
Loading...
