EN
4 - MOVEMENT AND INSTALLATION VIP80E-II
4 - Pag. 22 / 22
4.11 WORKING PARAMETERS SETTING
By means of a handheld keyboard you can assign the different parameter values according to
the operating characteristics of lathe - bar feeder coupling and to the working needs.
See the "Keyboard instruction manual" to assign adequate values.
4.12 BAR FEEDER TESTING
INFORMATION:
the bar feeder testing must be carried out following a preset procedure, which
is possibly indicated and authorized by the manufacturer.
During the bar feeder testing phase, check if the safety conditions are adequate and start it
only if this requirement is in conformity with the standards required.
To Next Page