Ier I420 - 2.8 ADJUST THE MEDIA THICKNESS

i420
User Guide
Ce document est la propriété d'IER et ne doit pas être reproduit ou communiqué sans autorisation écrite
This document is the property of IER and may not be reproduced or communicated without prior written
authorization.
Page 19
N0L802A1
2.8 ADJUST THE MEDIA THICKNESS
The media thickness adjustment dial allows you to adjust the thermal head
offset according to the media thickness. The default factory setting is 2. This
value is suitable for standard ATB and Bag Tag media.
Below process applies to nonstandard media.
1. Rotate the media thickness adjustment dial until you reach the desired
setting.
Dial
Type of media
0
Direct thermal media (thin paper)
1-2
Direct thermal label media, standard direct thermal media
3-5
Thicker media such as high quality direct thermal media
6-9
Cards, tags, thicker media stock
2. Do a print test (see page 18).
3. If necessary, adjust the setting to optimize the print quality:
 If the print is too bright, select a lower value.
 If the print is too dark, select a higher value.