Ier I420 - Safety Instructions

i420
User Guide
Page 4
N0L802A1
Ce document est la propriété d'IER et ne doit pas être reproduit ou communiqué sans autorisation écrite.
This document is the property of IER and may not be reproduced or communicated without prior written
authorization
SAFETY INSTRUCTIONS
WHICH MUST BE STRICTLY OBSERVED!
To prevent personal injury or property damage, the following shall be strictly observed.
The degree of possible injury and damage due to incorrect use or improperly following instructions is described
below.
INDICATES A SITUATION, WHICH, IF NOT OBSERVED AND HANDLED PROPERLY,
COULD RESULT IN DEATH OR SERIOUS INJURY.
Indicates a situation, which, if not observed and handled properly, could result in injury.
Warns against the presence of hot surfaces. Do not touch. To prevent skin burn injuries,
turn off, unplug and allow surfaces to cool down before servicing.
Warns against the risk of hand cuts or hand crushing. To prevent injuries, turn off, unplug
and wear gloves during servicing.
NEVER PERFORM THE FOLLOWING. IF NOT AVOIDED, THESE MAY CAUSE DAMAGE OR
TROUBLE TO THE PRINTER OR CAUSE THE PRINTER TO OVERHEAT AND RELEASE
SMOKE AND CAUSE BURNS OR AN ELECTRICAL SHOCK. IF THE PRINTER IS DAMAGED
OR IS MALFUNCTIONING, BE SURE TO TURN THE PRINTER OFF IMMEDIATELY AND
REMOVE THE POWER CORD FROM THE OUTLET, THEN CONSULT OUR SERVICE
PERSONNEL.
 DO NOT JOLT OR IMPACT TO THE PRINTER BY STEPPING ON, DROPPING OR
HITTING THE PRINTER.
 DO NOT PLACE THE PRINTER IN A POORLY VENTILATED AREA, OR SHUT OFF THE
AIR VENT OF THE PRINTER.
 DO NOT PLACE THE PRINTER WHERE CHEMICAL REACTIONS OCCUR, SUCH AS IN
LABORATORIES OR WHERE AIR IS
 MIXED WITH SALT OR GAS.
 DO NOT USE A POWER VOLTAGE OR FREQUENCY OTHER THAN THOSE
SPECIFIED.
 DO NOT PLUG/UNPLUG THE POWER CORD OR ATTACH/DETACH THE INTERFACE
CABLE BY SIMPLY GRABBING THE POWER CORD OR INTERFACE CABLE. DO NOT
PULL OR CARRY THE PRINTER WHEN THE TENSION OF THE POWER CORD OR
INTERFACE CABLE IS INCREASED.
 DO NOT DROP OR PUT FOREIGN MATTER SUCH AS CLIPS AND PINS INTO THE
PRINTER. THIS MAY CAUSE PROBLEMS.
 DO NOT PLUG THE POWER CORD INTO AN OUTLET WITH MANY LOADS.
 DO NOT SPILL DRINKS SUCH AS TEA, COFFEE AND JUICE ON THE PRINTER OR
SPRAY INSECTICIDE ON THE PRINTER. IF DRINK OR WATER IS SPILLED, FIRST BE
SURE TO TURN THE POWER OFF AND REMOVE THE POWER CORD FROM THE
OUTLET, THEN CONSULT OUR SERVICE PERSONNEL.
 DO NOT DISASSEMBLE OR MODIFY THE PRINTER.
THE PRINTER IS NOT TRANSPORTABLE.