Ier I420 - 4 TROUBLESHOOTING; 4.1 THE PRINTER DOES NOT START UP AT POWER UP; 4.2 THE PRINTER DOES NOT RECEIVE PRINT DATA

i420
User Guide
Ce document est la propriété d'IER et ne doit pas être reproduit ou communiqué sans autorisation écrite
This document is the property of IER and may not be reproduced or communicated without prior written
authorization.
Page 25
N0L802A1
4 TROUBLESHOOTING
In most cases, a printer operating fault activates the indicators and an audible
signal.
4.1 THE PRINTER DOES NOT START UP AT
POWER UP
1. Power down the printer (turn power switch to "O" position).
2. Check the presence of the AC power supply with another electrical
device.
3. Check the connections of the power cord to the printer power inlet and to
the power supply outlet.
4. Restart the printer (turn power switch to "I" position).
5. Wait for the printer to initialize then make sure that the LED indicator is lit
in green, in "On line" mode.
6. If the problem persists, call the help desk.
4.2 THE PRINTER DOES NOT RECEIVE PRINT
DATA
1. Power down the printer (turn power switch to "O" position).
2. Check the connections of the data cable to the printer data inlet and to
the computer system (computer, network, hub, etc.).
3. Restart the printer (turn power switch to "I" position) and make sure that
the LED indicator is lit in green,in "Online" mode.
4. Send a print command from the host system; the printer should perform
the requested task.
5. If the problem persists, call the help desk.