English
8
WARNING: Ensure that the product, before
-
stalled in a horizontal position by way of the
adjustable feet.
Check the horizontal position using a spirit
level.
Replacement of the inlet hose
• In case of breakage, the hose must be replaced
with an original spare part available from the
manufacturer or its service center.
Installation
• Remove all elements of the packaging.
WARNING: Keep packaging materials away
from children.
• Do not install or use the dishwasher if it is
damaged.
• Follow the instructions supplied with the product.
WARNING: Do not connect the dishwasher to
the mains supply until all installation opera-
tions have been performed according to the
“ASSEMBLY INSTRUCTION”.
WARNING: Do not connect the dishwasher
to the mains supply until the front panel has
been fully installed. Otherwise, the risk of an
electrical hazard may persist.
Safety instructions
Service
• To repair the appliance contact the Authorised
Service Centre. Use original spare parts only.
• Please note that self-repair or nonprofessional
repair can have safety consequences and might
void the guarantee.
• The following spare parts will be available for 7
years after the model has been discontinued:
motor, circulation and drain pump, heaters and
heating elements, including heat pumps, piping
and related equipment including hoses, valves,
parts related to door assemblies, printed circuit
boards, electronic displays, pressure switches,
including reset software. Please note that some
of these spare parts are only available to profes-
Water connection
The appliance must be connected to the water
mains using new hose-sets. The old hose-sets
should not be reused.
• The inlet and drain hoses can be directed to left
or right.
The dishwasher can be connected to either
cold or hot water, as long as it is no hotter
than 60°C.
• Water pressure must be between 0,08 MPa and
1 MPa.
• The inlet hose must be connected to a tap so
machine is not in use (g.1).
•
connector (g.2).
• Connect inlet hose “A” to water tap “B” with a
3/4” attachment making sure that it has been
properly tightened. For nordic countries (FI SE NO
DK) there is necessity to use adapter
(see assembly instruction).
• If it is necessary, the inlet pipe can be lengthened
up to 2,5 m. The extension pipe is available from
the After Sales Service Centre.
sional repairers, and that not all spare parts are
relevant for all models.
• The following spare parts will be available for 10
years after the model has been discontinued:
door hinge and seals, other seals, spray arms,
such as baskets and lids.
• Concerning the lamp(s) inside this product and
spare part lamps sold separately: These lamps
are intended to withstand extreme physical
conditions in household appliances, such as
temperature, vibration, humidity, or are intended
to signal information about the operational
status of the appliance. They are not intended to
be used in other applications and are not suitable
for household room illumination.
To Next Page
Loading...
