English
32
4
arms in the same position, remembering to
re-align the arrow and screw into position
(g.35).
4
5 Both the door lining and the tank lining are
in stainless steel; however, should spots
caused by oxidation occur, this is probably
due to a high level of iron salts presents in
the water.
6 The spots can be removed with a mild
abrasive agent; never use chlorine based
materials, steel wool, etc.
WHEN CYCLE IS FINISHED.
If the machine is not going to be used for some
time, it is advisable to follow these rules:
1 Do an empty wash with detergent in order
to clean the machine of any deposits
2 Pull out the electric plug
3
4 Fill the rinse aid container
5 Leave the door ajar
6 Keep the inside of the machine clean
7 If the machine is left in places where the
temperature is below 0°C any water left
inside the pipes may freeze. Wait until the
temperature rises above zero and then wait
4
(g.35)
1
2
Troubleshooting
If you believe the dishwasher is not working correctly, consult the quick guide provided below with some practical
Service Centre.
BUG REPORTS
Errors are reported by a number preceded by the letter “E” (e.g. Error 2 = E2) and a short audio signal.
.
.
.
.
..
.
.
To Next Page
Loading...
